When you want to apply grip tape to your longboard, you may need to have the subsequent: Skateboard deck, grip tape, box cutter or razor blade, and file. Below would be the step to properly apply them: sector 9 skateboards • Get rid of all traces of paper the grip tape’s rear. This will expose the sticky surface. •You need to use the piece of the backing paper to hold the surface of the tape to protect your hands from the sticky area. •Cut the grip tape additional than the dimensions of this midpoint of the board. Let the grip tape dangle a bit in the middle area. This is certainly to make sure that the tape on the board will stick inside middle firstly. Once the tape has stuck on the middle, you need to make sure that you meticulously stick on the edges and this has to be carried out from the middle onwards. Because this is really sticky, remember that you have to handle this very carefully. loaded longboard •So that you can scratch the outer place of this deck on the longboard, you will need to make use of a metal file or even the metal community of your screwdriver. Ensure that you rub firmly till the time all the grains are vanished. You also should just be sure you can see a white line visible and this must be viewed likewise inside the grip tape to help finding out the board’s limits. •To remove excess grip tape, grasp a razor blade on a 45-degree angle and cut from the base up. You need to do this starting at the nose or the tail. At the time you’ve undertaken this, transfer alongside the white outline and go the blade alongside the sides to cut added grip tapes. check this link •You’re able to use the metal file to levels all irregular edges just with regards to the sides in the longboard.•Last but not the least, you need to use the screwdriver to push holes from the grip tape where the trucks are located.